![]() The first method must be a credential such as a proximity patch, card, or key fob. Use Secondary Language: Display a secondary language.Ĭard Plus Pin: Use two access methods to operate the system from a keypad. They cannot access the first area again until they properly exit through the second area.Įasy Arm/Disarm: Arm or disarm all areas that are assigned to a code automatically. Profile members are required to properly exit (egress) an area that they previously accessed. Service Request: Request a service call from your alarm provider.Īnti-Passback: Use anti-passback. Set Time: Change the system date and time from a keypad’s User Menu. Schedules: Add, edit, or delete schedules. User Codes: Add, change, or delete user codes.Įxtend: Extend a schedule for 2, 4, 6, or 8 hours. Profiles: Add, change, or delete profiles. System Test: Initiate a system test from a keypad’s User Menu. Outputs On/Off: Turn outputs on or off from a keypad’s User Menu.īypass Zones: Bypass zones when arming the system. ![]() Lockdown Override: End a lockdown and restore the system.ĭoor Access: Grant temporary door access.Īrmed Areas: View armed areas at a keypad. A sensor reset is also required to clear a low battery (LOBAT) message after changing a wireless device’s batteries. A sensor reset is required for all smoke detectors, flood sensors, and temperature sensors that have triggered an alarm, as well as system restoral after a lockdown is ended. ![]() When enabled in a profile, these permissions allow profile members to perform the following actions:Īrm: Arm the system according to the options configured in Areas.ĭisarm: Disarm the system according to the options configured in Areas. Off: Do not allow profile members to access private doors. On: Allow profile members to access selected private doors. Only doors that have been configured as private doors by your security provider are displayed in Profiles. When enabled, these permissions allow profile members to access up to 4 private doors. Off: Do not allow profile members to access and edit a schedule. On: Allow profile members to access and edit a schedule. This setting supersedes Schedules in Profile Options. The Access setting supersedes Door Access in Profile Options.Īrm/Disarm: Allow users with this profile to arm and disarm an area.Īccess: Allow users with this profile to access an area. The Arm/Disarm setting supersedes Arm and Disarm in Profile Options. Enter the number of the output group that you want to assign to the profile. Output Group: Assign outputs groups to a profile, allowing an entire group of outputs to turn on or off as required like when door access is granted. Rearm Delay: When the user disarms an area outside of a schedule, delay automatic rearming by the number of minutes entered. Manually changing this number can cause conflicts when managing multiple systems in Admin. Leave this number as assigned unless you plan on using custom profile number configurations. Number: The ID number automatically assigned to the profile. Refer to the following information when configuring profiles.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |